M061
Break out the Nano I/O to screw terminals. Nano pins push fit into central female headers. Board provided as a kit so soldering assembly is required....
£1.36
Add:
M062
USB-to-Serial converter based on the CP2102 chip. For debugging, firmware updating and general serial communications. Connects to PC via micro-USB...
£2.06
Add:
M064
Double relay module. Inputs Gnd, Vcc (5Vdc), channel 1 signal (active low), channel 2 signal (active low). Channel signals are optically isolated...
£2.52
Add:
M065
Input 8V - 36Vdc. Output 1.25V-32Vdc Constant max. output current can be varied up to 5A. 75W max. Set the output voltage off load, then set the...
£2.62
Add:
M069
PIR motion sensor with operating in the 2.7V to 12Vdc supply range. Sensitivity 3-5m with output low to high for 2 secs on detection of motion....
£1.96
... more info Sold Out
M071
Clone of the Arduino Pro Mini with ATMega328P microcontroller operating at 3.3V 8MHz. 100% compatible. The Pro Mini was designed as a low cost...
£3.11
... more info Sold Out
M074
Clone of the Arduino Pro Mini with ATMega328P microcontroller operating at 5V 16MHz. 100% compatible. The Pro Mini was designed as a low cost...
£3.95
Add:
M075
8-Channel relay module. Inputs Gnd, channels 1-8 signal (active low), Vcc (5Vdc). Channel signals are optically isolated from the relay coils. Option...
£5.18
Add:
M077
Processor - Powerful ARM 32bit Cortex-M3 72MHz CPU 64K Flash memory & 20K SRAM. 33 I/O pins. and 3.3V operating voltage. Supplied with 0.1" pitch...
£3.94
... more info Sold Out
M081
4-Channel relay module. Inputs Gnd, Vcc (5Vdc), channel select signal 1-4 (active low). Channel signals are optically isolated from the relay coils....
£3.11
Add:
M082
DC buck converter module based on the MP2307 IC. Input 4.75V - 23Vdc. Output 1V-17Vdc Output variable by on board miniature preset potentiometer. Our...
£0.65
... more info Sold Out
M084
Wi-fi and Bluetooth capable development board using the ESP-WROOM-32 chip. 32-bit dual core processor. Up to 240MHz with 512kB RAM. Peripherals...
£7.26
Add:
M085
Motor driver shield for Arduino - compatible with the Adafruit motor driver library. The board includes two L293D motor drivers and one 74HC595 shift...
£3.37
... more info Sold Out
M087
Charger module for 3.7V lithium power (LiPo) packs which do not include their own protection circuit. Feeds a 1A charge current to the battery and...
£1.00
Add:
M088
2-channel H-bridge motor driver board able to drive two independent motors at up to 800mA each. Can also drive a single four line two phase stepper...
£1.19
... more info Sold Out
M089
RF remote control switch. Consists of receiver module with 10A changeover relay and key-fob remote control with extendable antenna and sliding cover....
£6.00
... more info Sold Out
M095
Stereo power amplifier based on the PAM8610 class-D chip. 7-15V dc supply, input impedance 15k, 4 Ohm - 8 Ohm output impedance. 15W+15W into a 4 Ohm...
£1.78
Add:
M098
4-channel 16-bit ADC with I2C interface. Arduino and Python libraries available. Differential input capability. Continuous Mode: Only 150μA...
£3.50
Add:
M099
Stereo amplifier with bluetooth connectivity. Operating voltage - 8-26V dc supply. Audio power output - 15W x 2 with 16V supply. Class D operation...
£3.80
Add:
M101
Stereo power amplifier based on the PAM8403 class-D chip. Module incorporates volume control with on/off switch at fully anti-clockwise rotation....
£0.94
Add:
MTR8
Motor voltage range 3-12Vdc (5V-9V recommended). 70-250mA Motor & gearbox dimensions 70 x 22 x 18mm approx. 70-140 rpm approx. Torque 1kgf.cm approx....
£2.38
... more info Sold Out
PCB013
Prototyping double-sided pad board fits the Wemos D1-Mini wi-fi board headers.
£0.61
Add:
QU328
Stereo power amplifier based on the PAM8403 class-D chip. 2.5-5V dc supply and highly efficient class of operation make this ideally suited to...
£0.72
Add:
ST053
Detect the distance to objects in front of the sensor using an ultrasonic ping. 5V operation suitable for use with microcontrollers, Arduino, etc. An...
£1.72
... more info Sold Out
ST071
Triaxial accelerometer and gyroscope with 6 degrees of freedom. I2C serial interface. 5Vdc supply voltage - Arduino friendly. Applications available...
£2.06
... more info Sold Out
ST089
A successor to the HC-SR04 with reportedly improved range (around 4.5m) and accuracy. Detect the distance to objects in front of the sensor using an...
£2.09
... more info Sold Out