K102
Red, amber, green LED traffic light simulator. Should be powered by a PP3 battery - see the battery section. If you require wire - see the cable...
£5.65
Add:
OP126
10mm Super Bright Green LED with water clear lens. 30,000mcd 3.2Vf@20mA, Ifmax continuous=25mA, 30deg viewing angle. Ifpeak 100mA 0.1ms pulses, 1/10...
£0.29
Add:
XH3PHRA
XH pcb-mount right angle 3-pin header. Pin pitch 2.5mm.
£0.08
Add:
HW125
A budget priced single piece led clip for 3mm leds. Fits an 6mm hole in panels up to 2.5mm thick.
£0.16
Add:
HW191
Lens and panel clip for 3mm LEDs. Clear plastic with diffusing rings. Lens diameter 5mm. Overall length 7.3mm. Fit into 4.35mm panel hole and snap in...
£0.47
Add:
HW094
Plastic clip to mount 10mm LEDs
£0.22
Add:
CN288
Pre-assembled leads of 1.8m in length, moulded-on power plug, stripped and tinned wires at the free end and moulded-on strain relief bush. Standard...
£1.18
Add:
OP084
10mm Standard Brightness LED 36mcd 2.4Vf lfmax=25mA
£0.21
Add:
CN289
Pre-assembled leads of 1.8m in length, moulded-on power plug, stripped and tinned wires at the free end and moulded-on strain relief bush. Standard...
£1.35
Add:
OP109
10mm High Brightness LED with water clear lens. 8500mcd 2.9Vf@20mA, Ifmax continuous=25mA, 30deg viewing angle.
£0.27
Add:
M071
Clone of the Arduino Pro Mini with ATMega328P microcontroller operating at 3.3V 8MHz. 100% compatible. The Pro Mini was designed as a low cost...
£3.77
Add:
OP040
Right Angled PCD mount 5mm LED. 32mcd 2.0Vf lfmax=30mA
£0.28
Add:
OP115
RED 8x8 dot matrix display - common anode. Vf=1.9V, Ifmax=18mA Row pins are connected to LED anodes.
£0.88
Add:
OP105
RED 8x8 dot matrix display - common anode. Vf=1.9V, Ifmax=18mA
£1.36
Add:
OP041
Right Angled PCD mount 5mm LED. 32mcd 2.2Vf lfmax=25mA
£0.45
Add:
OP120
10mm High Brightness LED with water clear lens. 5800mcd 3.1Vf@20mA, Ifmax continuous=30mA, 30deg viewing angle.
£0.29
Add:
XH4PHRA
XH pcb-mount right angled 4-pin header. Pin pitch 2.5mm.
£0.08
Add:
K118
"One of the most iconic and sought after amps in history ... in a pedal!" A kit of components as recommended by Ivlark for assembly of the Shin's...
£22.69
Add:
OP148
Kingbright L-7104LID 3mm Red LED. 3mcd brightness maintained down to 2mA forward current. Vf = 1.7V (2.5V max). If = 30mA max.
£0.15
Add:
OP135
Water clear lens, standard brightness. 35mcd 2.0Vf lfmax=20mA
£0.13
Add:
OP048
Right Angled PCD mount 5mm LED. 32mcd 2.1Vf lfmax=30mA
£0.26
Add:
OP143
1.8 inch TFT display using the ST7735 chip with 128x160 colour pixels. Rear mounted SD card slot allows bmp images stored on the card to be shown on...
£4.78
Add:
OP149
Kingbright L-7104LGD 3mm green LED. 2mcd brightness maintained down to 2mA forward current. Vf = 1.9V (2.5V max). If = 25mA max.
£0.17
Add:
OP009
3mm Standard Brightness LED 65mcd 1.9Vf lfmax=20mA. Lead length 18mm max.
£0.10
Add:
OP096
1602 LCD Module Yellow/Green LED backlight. Alphanumeric dot matric. 32 characters over 2 lines. Display area 66x16mm. 5V supply voltage. Arduino...
£2.72
Add:
OP015
3mm Standard Brightness LED 38mcd 2.5Vf lfmax=20mA. Lead length 18mm max.
£0.10
Add:
OP150
Kingbright L-7104LYD 3mm yellow LED. 2mcd brightness maintained down to 2mA forward current. Vf = 1.85V (2.5V max). If = 30mA max.
£0.13
Add:
OP112
1602A lcd module with blue LED backlight. Alphanumeric dot matrix. 32 characters over 2 lines. Display area 66x16mm. 5V supply voltage. 4x3mm fixing...
£2.72
Add:
OP132
Green/Yelow LED backlight. Alphanumeric dot matrix. 80 characters over 4 lines. Display area 76x26mm. Display bezel 98x40mm. 5V supply voltage....
£6.16
Add:
OP163
3mm Kingbright L-34GD LED 32mcd 2.2Vf lfmax=25mA. Lead length 28mm max.
£0.18
Add: