Optoelectronics

Optoelectronics:		Price each
Optoelectronics:		1+	10 pack
LED 5mm std brightness. Also available as part of a multi-led development kit - see below.	RED 65mcd 2.1Vf Ifmax=15mA	0.09	0.07
	GREEN 47mcd 2.4Vf Ifmax=20mA	0.10	0.08
	YELLOW 36mcd 2.4Vf Ifmax=20mA	0.10	0.08
	AMBER/ORANGE 50mcd 2.4Vf Ifmax=20mA	0.10	0.08

LED mounting hardware also available.

Rt Angled PCB mount 5mm LED Housed in a plastic moulding. Ideally mounted on the edge of a pcb. Pins on a 0.1" pitch.	RED 32mcd 2.0Vf	0.20
	GREEN 32mcd 2.2Vf	0.20
	YELLOW 32mcd 2.1Vf	0.20

LED 3mm std brightness. Also available as part of a multi-led development kit - see below	RED 65mcd 2.1Vf	0.09	0.07
	GREEN 47mcd 2.4Vf	0.10	0.08
	YELLOW 36mcd 2.4Vf	0.10	0.08
	AMBER/ORANGE 50mcd 2.4Vf	0.10	0.08

LED Rectangular 5x2mm. Std brightness.	RED 65mcd 2.1Vf	0.09	0.07
	GREEN 47mcd 2.4Vf	0.10	0.08
	YELLOW 36mcd 2.4Vf	0.10	0.08

LED 5mm high brightness - water clear lens. 476mcd min, typically 1900mcd at 20mA. 1.95Vf - 2.4Vf Also available as part of a multi-led development kit - see below	RED	0.12	0.10
	GREEN	0.12	0.10

BLUE LED Ultra Bright 5mm or 3mm Water clear lens.	5mm BLUE 8500mcd 3.3Vf	0.30	0.25
BLUE LED Ultra Bright 5mm or 3mm Water clear lens.	3mm BLUE 3500mcd 3.3Vf	0.30	0.25

WHITE LED 5mm - a choice of two very high brightness devices. Water clear lens.	WHITE 12000mcd 3.4Vf 30mA	0.30
	WHITE 30000mcd 3.6Vf 50mA	0.46
WHITE LED 3mm	WHITE Diffused Lens 1000mcd 3.3Vf 20mA	0.32
WHITE LED 3mm	WHITE Clear Lens 5000mcd 3.3Vf 20mA	0.35

Flashing 5mm LED. Built-in oscillator circuit provides a flash at approximately 1.5Hz. High brightness 1560mcd. Vdd = 2.5V - 3.3V I = 25mA	RED Water Clear Lens	0.30

Ultra-Violet 5mm LED. Freq. 395nm. 30mW UV power. Vf=3.5V Ifmax=30mA		1.00

Bicolour 5mm LED - a choice of 3 colour combinations.	RED/GREEN	0.20
	RED/YELLOW	0.22
	GREEN/YELLOW	0.22
LED Bar - 10 segment RED		0.95

LED Selection / Development Kit A collection of 10 x 5mm Std RED, 5 x 5mm Std GREEN, 5 x 5mm Std YELLOW, 10 x 3mm Std RED, 5 x 3mm Std YELLOW, 5 x 3mm Std GREEN, 5 x High Brightness RED & 5 x High Brightness GREEN. The kit also contains 70 resistors in values typically used as LED series resistors - 150R, 330R, 470R, 560R, 680R, 820R and 1k. There is also a guide to using LEDs and resistor selection.	50 LEDs PLUS 70 Resistors	3.29

CNY17-3 transistor o/p optocoupler.		0.34
HCPL-817 Optocoupler with transistor output.		0.34
K3020P Optocoupler with phototriac output.		0.38
6N139 Darlington Optocoupler		0.75

High speed 875nm infrared emitter 5mm - TSHA5200		0.18
Infrared emitter 5mm TSAL6400 940nm.		0.22
Infrared emitter 5mm TSUS5400 940nm.		0.15	0.10
BPW41 High Speed PIN Photodiode Sensitive IR sensor spectrally matched to the TSUS5400. Ideal for infrared remote control and data transmission circuits.		0.90
TSOP2438 IR Receiver Module. Detects 38kHz modulated infrared. Built in pre-amp and filter. 4.5-5.5V operation. Active low output.		0.98
Infrared Phototransistor IR Detector 940nm. L-7113P3C		0.29	0.25
HLC2701 Opto-sensor, encoder. Used in conjunction with an infrared led, this device can sense speed and direction of mechanical motion.		2.50

7-Segment LED .	7-Segment LED - 0.56" RED common cathode	0.55	0.50
	7-Segment LED - 0.56" RED common anode.	0.55	0.50
	7-Segment LED - 0.3" RED common cathode. OUT OF STOCK	0.48
	7-Segment LED - 0.3" RED common anode.	0.48

3mm filament lamps - wire ended. Grain of Wheat bulbs. Clear lens. Available in 6V 60mA and 12V 80mA.		6V-60mA 0.29
		12V-80mA 0.29

Lampholder - MES E10		0.32
Filament Bulb - 6V or 12V MES E10		2.5V 200mA 0.14
		6V 60mA 0.12
		12V 100mA 0.14
Neon Panel Indicator 220Vac rated. 12.5mm diameter. 9.5mm panel cut out. Overall length 42.7mm.		RED 0.52
		AMBER 0.52